Registered: February 3, 2005 Location: Post Falls, ID Posts: 34
Fri, Apr 08, 2005 @ 5:33 PM
I used a 1/8" drill bit. Just make sure your helping-hubby drills the hole close to the edge/top of the domino. Otherwise, it's difficult to find a jump ring that will fit properly. Happy drilling!
Registered: February 3, 2005 Location: Post Falls, ID Posts: 34
Fri, Apr 08, 2005 @ 7:20 PM
If someone could tell me how to "pm", I'll send instructions. I can't get on the forum at this time.
I used a multipurpose drill bit. I figured if it would drill through metal, it should penetrate a domino. It worked just fine