Registered: October 18, 2011 Location: Idaho Posts: 127
Tue, Sep 04, 2012 @ 7:46 AM
Ummm. Not yet. Basically:
I cut the chip board to the size I wanted (2 per page). I stitched the pages together at the top and bottom to make the pocket. I created a hinge using chipboard and then stitched each pocket page to the hinge.
For the flaps, I cut the chipboard the size I wanted, cut a piece of cardstock 1 inch by the length of the side I was attaching it to.
Then I stitched the cardstock to the chipboard. After it was all together, I covered each page with pattern paper and embellishments.
The ribbon goes through the cover (under the inside page) and around the binding.
My plan it to make a few more and then take pictures of the process as I go. I'll post it to my blog when I have it done