"Happy Holidays" paper and red metal dots from Hobby Lobby. Vanilla and red cardstock from SU. Round circle punch by Fiskars used for paper
circles behind red metal dots. Candy Cane embossing folder by Cuttlebug used on the vanilla cardstock. **The green tree is a new EK Success tree punch. The small red tree is from a squeeze punch by Fiskars. The gold star is punched from paper by Petals at Joanns. Pop dots were used for dimension behind the green tree. The card is Kraft paper by Paper Trey Ink.
**To allow for your tree to be on the edge of the card and still fit into your envelope cut the card a little smaller in width than usual. Clean and simple card. Inspired by Splitcoast.
Registered: July 29, 2007 Location: Raleigh, NC Posts: 274
Sat, Oct 30, 2010 @ 1:45 PM
No--the card is all on top of the Candy Cane folder embossed piece--the cream piece. I cut that piece and then cut the red behind the Happy Holidays print. You cut the red into a square. Then make a pencil dot in the center of one edge of the red--the sshort side. Then take that to the paper cutter and cut the paper from the center dot to the lower corner on both sides and this makes your triangle. No tucking it in---Then the Happy Holidays print I did the same and once that was a triangle I then trimmed off 1/4 inch on the two sides and the bottom side so it would fit on top of the red triangle. I hope this is clear--Candee P