I made this little Gift Card Envelope for my SIL who we picked out in our family's Kris Kringle to fit the Coles-Myer Gift card that my SIL had on her Gift List.
When I make another one, I will tie the ribbon around the dp panel BEFORE I attach it to the card front so that it hides the ribbon and looks neater.
The width of the holder is 135mm and the length is 167mm. I made folds at 70mm and 145mm. PM me if you want the imperial measurements, ie: inches.
The sentiment is popped up on 1mm mounts.
See my next photo for the inside view.
Thanks for having a peek!
Edited to add: conversion from metric to imperial -
see 2nd comment below
NOTE: that if you are adding the scallop border on the inside flap that holds the card, make sure you add a little extra length because you will "punch" off about 1/2" (13mm) when you use the punch.
Make one out of paper first to check all your measurements and adjust where necessary.
Date: Friday, December 11, 2009 GMT Views: 918
Favorited:7
Remember that if you are adding the scallop border along the inside edge that folds over to hold the card, add a little bit extra to the length because you will "punch" off approx. 1/2" (13mm) of cardstock when you use the punch. So that would mean you would need to adjust the length from 6-5/8" to 7-1/8".
Make one out of paper first to check your measurements before you cut up your cardstock.