Dimensional Banners
by Toni Storie
Use Scor-Pal products to create dimensional banners for your card sentiments.
Supplies
- Scor-Pal or Scor-Buddy and Scor-Tool
- Cardstock strip
- Paper trimmer
- Square punch or die
- Dimensional tape
- Sentiment stamp
- Stamps, cardstock, and other embellishments as needed to complete the project
Step-by-Step
-
Step 1
Stamp a sentiment on a long, narrow strip of cardstock. Trim the strip 1.25” from either side of the stamped image.
-
Place the strip against the top fence of the Scor-Buddy and score at 7/8” and 1”. Turn the cardstock 180 degrees and score again at 7/8” and 1”.
-
Step 2
Crease on the 1” score lines, folding banner tails toward the back.
-
Crease on the 7/8” score lines, folding the banner tails forward again.
-
Step 3
Trim the banner tails with the corner of a square punch or die, and place dimensional adhesive on the back of the banner.
-
Step 4
For an angled banner, center and stamp a sentiment on a strip of cardstock.
-
Step 5
Align the edge of the sentiment at the desired angle on the first of the 1/8” grooves. Score on the first and second of these grooves.
-
Turn the cardstock strip 180 degrees and repeat the step above.
-
Step 6
Crease the inside score back and the outside score forward, as before.
-
Step 7
Trim banner tails with a square punch or die and apply dimensional adhesive as before.
-
Step 8
Use the banner to embellish a card.
-
Video!
Your Turn
You've seen the tutorial, now you try it! We've got a section of the gallery set aside for Dimensional Banners. Try this technique, then upload your artwork to the gallery. Show us your creations!
***Please note - Internet Explorer/Edge is not a supported browser, and will not allow you to see the videos. Please use Chrome, Firefox or Safari to view our tutorial videos.
Questions and Comments
We'd love to get your feedback or questions. Leave your comment below.
Scor-Pal or Scor-Buddy and Scor-Tool
Easy to understand step by step instructions
Regards Helen :o)
Page 1 of 1 pages