For the card base cut a piece of blue cardstock 6”x 12”, score at 6” and fold it in half. Cut 3 - 6” squares from the Heartfelt Creations “Birds and Blooms” Paper Collection. Use 1 sq. for the card front and the other 2 for the inside. Trim each square so they are just a tiny bit smaller than the card base and adhere to the card.
Cut/Emboss white cardstock for the inside verse using “Marianne Creatables Petra’s Heart die”. Before removing the die, sponge embossed areas using Green ink. Add Dimensionals and set aside until you finish the card front.
Using the tag die from “Spellbinders Valiant Honor Die” cut it 12 times out of white cardstock and 12 times out of DSP. Spray each of the white tags with “Krylon Permanent Spray Adhesive”. NOTE: If you use heavy DSP you don't need to cut the tags out of white cardstock.
Carefully, line up the top edges of the DSP to the top of the white tags and press in place. Repeat on the other tags. Let dry.
Sponge edges with Pink chalk ink. Use a “Quickie Glue Pen” to go over the long edges of the fan pieces and then dip them into white glitter. Join the tags to make the fan shape: On the bottom filigree you will see a tiny diamond shape. I took a thin piece of white floral wire and threaded it through the diamond shaped hole on all 12 tags. Then, I twisted the ends and flattened them against the filigree edge so the tags wouldn't come apart. See the picture with the circle on the bottom of the filigree.
Take pieces of removable tape and place it on the back of the fan. Spread out the fan pieces out the way you want them to look and adhere them to the tape so they stay in place. Turn fan over and use Diamond Stickles on the top Filigrees. Let dry thoroughly.
The 4 corner dies are from Cuttlebug Vintage Dies #37-1201, cut out of the same DSP as the fan.
NOTE: In order to cut the Cuttlebug dies with foam on the die with your Grand Calibur; you will need the Raspberry Plate “D” and the Cutting Plate “C”. If using thin DSP cut 2 at once; If using thick paper cut 1 at a time.
Use Diamond Stickles on the 4 corner dies. Let dry and glue in place. I put some glue on a piece of paper and used a toothpick to place dots of glue on the corner pieces. Let dry thoroughly.
The 3 small roses and rose buds were made using the Marvy 1”- 6-Petal Flower Punch; Remove the tape from the back of the fan. Adhere fan to card using Dimensionals stacked 2 high. Adhere bow to bottom of fan. Arrange Roses and leaves around center of the bow. Cut 1 Cheery Lyn Add a Flourish B456 in green. Add 3 rose buds to it. Add Baby’s Breath around roses.
Happy Birthday is stamped and cut out using SU! Word Window Punch
Date: Saturday, February 13, 2016 GMT Views: 399
Favorited:4