Registered: March 2, 2008 Location: Folsom, CA Posts: 9567
Fri, Oct 24, 2008 @ 8:53 PM
Thanks for the comments on the room
I made my stamp pad holders. I measured out the size I wanted and went to Tap Plastic (they sell and cut acrylic) and had them cut the pieces. I glued them with acrylic glue. They cost about $15 each. If you were to look close I have glue drips but it's ok for me The glue is pretty stinky and real runny. the racks are over 2 yrs old and are holding up well. The hardest part was geting the measurements right. I should have saved them because I want to make another one and now I have to start over. If you decide to make one its really easy.